Dixon ZTR 5425, ZTR 5023 manual Specifications, Model ZTR

SPECIFICATIONS

Model ZTR 5020

CHASSIS:	11 GA - rectangular tube
BODY:	Two piece - made of rotational molded polyethylene. Front		body
	contains access panels for battery service and engine to mower deck
	belt removal. Rear body tilts up to allow service on the entire drive
	system.
SEAT:	Designed for operator comfort by use of high density closed cell foam
	padded back rest and arm rests, upholstered with CorduraTM		water-
	repellent fabric. Seat is adjustable fore and aft.
MOWER DECK:	2 Decks are available. 60" is made of stamped steel. 50" is made of
	11 GA fabricated welded construction with external reinforcement
	ribs. 3 blades combine for either a 50" or 60" cut width.
	Cut height	approximately 1.5" to 4.5" via 7 position lift handle.
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear BDU-10L
	Series 70 hydrostatic transmission. The hydrostatic transmissions, in
	turn, power a fully enclosed HydroGear gearbox.
ENGINE:	20HP Briggs & Stratton Intek, overhead valves, replaceable oil filter,
	full pressure lube system, dual element air cleaner, integral fuel pump.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake
	and blade drive clutch.
TIRES:	Front	11 X 4 X 5 smooth profile
	Rear	20 X 10 X 8 Multi Trac
RECOMMENDED	Front	16 - 21 lbs.
TIRE PRESSURE:	Rear	8 - 14 lbs.
CAPACITIES:	Fuel - 4.8 gallons total (dual tanks)
	Hydrostat oil tank - 3 quart with in-line 40 micron filter
	Hydrostat oil recommendation, refer to page 36
	Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS:	Width	60"(50" Deck), 73"(60"Deck)
	Height	45"
	Length	72"
	Weight	668 lbs. (50" Deck), 685 lbs. (60" Deck)
NOTE:	Additional information provided in service instructions under the
	individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 11