Bryant 593C warranty SPECIFICATIONS Continued, Unit Size, 042-C,D, 048-C, 060-C, Electrical

SPECIFICATIONS Continued

UNIT SIZE		042-C, D	048-C		060-C
Operating Weight (Lb)		206	199		217
ELECTRICAL
Unit Volts—Hertz—Phase			208–230—60—1
Operating Voltage Range*			197—253
Compressor— Rated Load Amps		19.0	24.4		28.8
	Locked Rotor Amps	105.0	140.0		165.0
Condenser Fan Motor—Full Load Amps		1.4	1.4		1.4
Min Unit Ampacity for Wire Sizing		25.2	31.9		37.4
Min Wire Size (75°C Copper) AWG†		10	10		8
Min Wire Size (60°C Copper) AWG†		10	8		8
Max Wire Length (Ft) (75°C Copper)‡		73	59		78
Max Wire Length (Ft) (60°C Copper)‡		77	97		82
Max Branch Circuit Fuse Size**		40	50		60
COMPRESSOR and REFRIGERANT
Compressor—Manufacturer and Type		Copeland Reciprocating	Millennium Scroll		Millennium Scroll
Temperature and Current Protection		Internal Line Break	Internal Line Break and Dome Thermostat
Refrigerant—Type and Amount (Lb)††		R-22 and 5.51	R-22 and 7.63		R-22 and 10.63
CONDENSER COIL and FAN
Coil Face (Sq Ft)		12.2	15.2		18.3
Fins per In.—Rows—Circuits		20—1—2	25—1—3		25—1—4
Fan Motor—HP, Type, and RPM			1/4 PSC and 1100
Volts—Hertz—Phase			208/230—60—1
Condenser Airflow (CFM)			3000
OPTIONAL EQUIPMENT
Support Feet			KSASF0101AAA
Coastal Filter			KAACF0801MED
Time Delay Relay			KAATD0101TDR
Cycle Protector			KSACY0101AAA
Crankcase Heater		Standard		KAACH1201AAA
Start Assist—Capacitor/Relay Type		KSAHS1301AAA		KSAHS1601AAA
Start Assist—PTC Type			KAACS0201PTC
Sound Hood		KSASH1201COP		KSASH2001CYL
TXV Kit (RPB)		KAATX0501RPB	KAATX0601RPB		KAATX0701RPB
TXV Kits (Hard Shutoff)		KSATX0601HSO		KSATX0701HSO
Low-Pressure Switch			KAALP0101LPS
High-Pressure Switch			KSAHI0101HPS
Filter Drier			P502-8163S (RCD)
Evaporator Freeze Thermostat**			KAAFT0101AAA
Liquid-Line Solenoid Valve			KAALS0101LLS
Winter Start Control**			KAAWS0101AAA
Low-Ambient Kit			KSALA0201R22
MotorMaster® Control††			32LT660004 (RCD)
Ball Bearing Fan Motor			HC40GE232 (RCD)
Thermostat, Auto Changeover,
Non-Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool			TSTATBBNAC01-B
Thermostat, Auto Changeover,
7-Day Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool			TSTATBBPAC01-B
Builder’s Thermostat, Manual
Changeover, Non-Programmable,
°F/°C, 1-Stage Heat, 1-Stage Cool			TSTATBBBAC01-B
Thermidistat™ Control—Programmable/
Non-Programmable Thermostat with
Humidity Control			TSTATBBPRH01-B
Outdoor Air Temperature Sensor			TSTATBBSEN01-B
Backplate for Non-Programmable
Thermostat			TSTATXXNBP01
Backplate for Programmable Thermostat			TSTATXXPBP01
Backplate for Builder’s Thermostat			TSTATXXBBP01
Thermostat Conversion Kit (4 to 5 wire)
— 10 Pack			TSTATXXCNV10

*Permissible limits of the voltage range at which the unit will operate satisfactorily. Operation outside these limits may result in unit failure.

† If wire is applied at ambient greater than 30°C (86°F), consult Table 310-16 of the NEC (ANSI/NFPA 70).

The ampacity of nonmetallic-sheathed cable (NM), trade name ROMEX, shall be that of 60°C (140°F) conductors per the NEC (ANSI/NFPA 70) Article 336-26. If other than uncoated (non-plated), 60° or 75°C (140° or 167°F) insulation, copper wire (solid wire for 10 AWG and smaller, stranded wire for larger than 10 AWG) is used, consult applicable tables of the NEC (ANSI/NFPA 70).

‡ Length shown is as measured 1 way along wire path between unit and service panel for a voltage drop not to exceed 2%.

**Fan motor with ball bearings required. See Low-ambient controller Installation Instructions for application.

NOTE: Copper wire must be used from service disconnect to unit. All motors/compressors contain internal overload protection.

—5—