DLS Svenska AB A2 WIRING EXAMPLES A5, ULTIMATE A5, Connection of a front system in, Button in

							ULTIMATE A5
WIRING EXAMPLES A5					You can use all DLS coaxial, 2-way, 3-way systems and
					subwoofers in this example.
Connection of a front system in					All speakers must be 2-4 ohm. If the head unit has only one
stereo and a subwoofer in mono.					pre out, a Y-cable must be used.
					For power cable, speaker cable and fuse size selection see
					page 4.
DC - FEED DLS A5							Use a 2 mm hexagon key to speaker and
			POWER IN			FAN
							fan terminals. Use a 2,5 mm hexagon key
FUSES 30 A x 3			BATT+ REM GND
				POWER			to the remote terminal. Use a 3 mm hexa-
					-	+
30	30	30					gon key to DC input terminals.
				PROTECT
							DLS A5 front channels are 2 ohm stable. DLS
	Fuse						A5 mono channel is 1,33 ohm stable. This
							means that you can connect three 4 ohm
	100 A
							subwoofers in parallel without damaging the
							amplifier. If you have a 4 ohm sub with dual
			+				voice coils you can connect the coils in parallel.
		Battery			Fan 12 V
		12 volt
			To remote
			on stereo / CD
							Subsonic-filter setting: IN (fixed 25 Hz)
HP-filter setting: 80 Hz							LP-filter setting: 70-80 Hz

Button in Button in

REAR SPEAKERS

+LEFT- +RIGHT-

+-

- +

LEVEL	HP-filter	SIGNAL INPUTS		Subsonic	Filter		SUBWOOFER
		FRONT	SUB		Low-Pass	LEVEL
IN				IN			+ SPEAKER -
		LEFT RIGHT LEFT RIGHT
3,5V	110				65	3,5 V
7V 0,2V	80 150				40 90	7,0 V 0,2 V
OUT	Hz			OUT

Pre out	Pre out
front	sub or
	rear
	FM1 107,3

Subwoofer 4 ohm

PHASE SHIFT CONTROL

Left side of A5 (part of)

Remote
Bass level /	IN
Phase
	Phase
0	+180 OUT

Remote Bass Level & Phase control

Level

Phase

The Phase shift control is variable from 0 to +180 degrees. With this control you can fine tune your subwoofers so they play in phase with the rest of your system.

REMOTE BASS LEVEL & PHASE SHIFT

A remote bass level & phase shift control is included. This allows you to adjust the bass level and phase shift from the front seat of your car.

Connect it to the socket marked Remote Bass Level. When using a remote level control you must activate it by pushing the switch on the right side of the socket, to IN-position.

17