WIRING EXAMPLES A6
Connection of two 4 ohm subwoofers
ULTIMATE A6
DC - FEED DLS A6
You can use all DLS subwoofers in this example. All speakers must be
PHASE SHIFT CONTROL
The Phase shift control is variable from 0 to
+180 degrees. With this control you can fine tune your subwoofers so they play in phase with the rest of your system.
This feature is extremely useful when fine tuning the different speakers and amplifiers of a SPL competition vehicle.
REMOTE BASS LEVEL & PHASE SHIFT A remote bass level & phase shift control is included. This allows you to adjust the bass level and phase shift from the front seat of your car.
Connect it to the socket marked Remote Bass Level. When using a remote level control you must activate it by pushing the switch on the left side of the socket, to
|
| POWER IN | POWER IN /POWER CAP |
| |
| FUSES | BAT+ REM GND | GND FAN OUT POS+ | FUSES | |
| 35 A x 2 | POWER |
| 35 A x 2 | |
35 | 35 | PROTECT |
| 35 | 35 |
Fuse 150 A
To remote
+on stereo / CD
|
|
|
|
|
| Power |
| Battery | Fan12 V | ||||
| 12 volt | capacitor | ||||
|
| |||||
|
|
| ||||
|
|
|
|
|
|
|
Subsonicfilter setting: IN (fixed 25 Hz)
LP-filter setting: 70-80 Hz
Button in
SIGNAL INPUT | Sub | Remote Bass |
sonic | Level | |
LEFT RIGHT | IN | IN |
| OUT | OUT |
SPEAKERS
Phase | LEVEL | - + | - | ||||
|
|
|
|
| + | ||
| +90 | 90 | 3,5V |
|
| ||
0 | +180 | 50 | 125 | 7,0V | 0,2V |
|
|
FM1 107,3
Level
Phase
Remote Bass | Subwoofer | Subwoofer | |
Level & Phase | |||
4 ohm | 4 ohm | ||
control | |||
|
|
DLS A6 has a
To get the best performance and cooling, mount the amplifier on spacings. Doing so the fan can get fresh air for best possible cooling.
The amplifier becomes very hot, especially when loaded down to 1 ohm. When using 1,33 and 1 ohm loads we recommend the use of external cooling fans as well.
DLS A6 is 1 ohm stable. This means that you can connect four 4 ohm subwoofers in parallel without damaging the amplifier. If you have a 4 ohm sub with dual voice coils you can connect the coils in parallel, one coil to each amplifier output.
NOTE!
The speaker output terminals are internally connected in parallel. This is a mono amplifier so it is not able to connect the outputs in bridge mode. The double terminals are only for easier connection of more than one subwoofer.
18