ULTIMATE A3
WIRING EXAMPLES DLS A3
On the following pages you find some examples of how to connect the amplifier for different use. The drawings show normal level and filter settings. The two channels are divided into two separate mono amplifiers. There are separate DC inputs for each channel but they are internally connected with each other. You can feed the amplifier with double DC feeds if you want a minimum of voltage drop, or you can also use the extra
DLS A3 can be connected in different ways:
1.As a stereo amplifier connected with a speaker system of coaxial,
2.As a subwoofer amplifier with max two 4 ohm subwoofers in mono bridge mode. The
1.In stereo with one front and one rear speaker system.
You can use all DLS coaxial,
For power cable, speaker cable and fuse size selection see page 4.
DC-FEED DLS A3
|
| POWER IN | POWER IN /POWER CAP |
| |
LEFT FUSES | BAT+ REM GND | GND FAN OUT POS+ | RIGHT FUSES | ||
| 30 A x 2 | POWER |
| 30 A x 2 | |
30 | 30 | PROTECT |
| 30 | 30 |
Fuse 150 A
To remote
+on stereo / CD
|
|
|
|
|
| Power |
| Battery | Fan12 V | ||||
| 12 volt | capacitor | ||||
|
| |||||
|
|
| ||||
|
|
|
|
|
|
|
Highpass filter not in use. Lowpass filter not in use.
SIGNAL INPUT | Phase | LEVEL | ||||||
LEFT RIGHT |
| IN |
|
| +180 | IN |
|
|
100 | 90 |
|
| 3,5V | ||||
|
|
| ||||||
| 20 | 200 | 15 | 125 |
|
| 7,0V | 0,2V |
|
| OUT |
|
| 0 | OUT |
|
|
Button out
Pre out
FM1 107,3
SPEAKERS
+LEFT- +RIGHT-
+-
-+
+-
-+
If you have problems with the mid bass dri- ver ”reaching the bot- tom” (the voice coil touches the bottom pole plate) at high volumes, use the HP- filter to avoid this with a setting at 50 - 80 Hz or higher. Make your own tests.
12