–First place the machine on the ground.
–Give a gentle push on the primer pump (2) repeatedly
– Push the choke lever (3) to the position “ | ”. |
| (3) |
(2)
–Firmly hold the clutch case by your left hand, as illustrated.
–Slowly pull the starter grip until resistance is felt and continue with a smart pull.
–Do not pull out the starter rope to its full extent and do not allow the starter handle to be retracted without control, but ensure that it is retracted slowly.
–Repeat the starting operation until initial ignitions are heard.
–When the engine start, return the choke lever to “ ”. Please note that the choke lever will return to “ ”position automatically when the throttle lever is operated and the throttle is opened.
–Run the engine for approximately one minute at a moderate speed before applying full throttle.
Note: – If the starter handle is pulled repeatedly when the choke lever remains at “ ” position, the engine will not start easily due to excessive fuel intake.
–In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Also,dry the electrode section of the spark plug.
Caution during operation:
If the throttle lever is opened fully in a
Starting the warm engine
–Same as adove, except without moving the choke lever (choke lever remains in the position “ ” ).
STOPPING
–Release the throttle lever (6) fully, and when the engine rpm has lowered, push the
–Be aware that the cutting head may not stop immediately and allow it to slow down fully.
ADJUSTMENT OF LOW-SPEED ROTATION (IDLING)
The cutter blade or the nylon cutting head should not run when the control lever is fully released. If necessary, adjust the idle rpm using the idle adjusting screw.
Checking the Idling speed
–Idle speed should be set to 2,600 /min.
If necessary correct it by means of the idle screw (the cutting blade must not turn when the engine is on idle).
Screwing in the screw (1) will cause an increase in the engine speed, whereas backing off the screw will reduce the engine speed.
12