Dometic 3000 Series Automatic Flush Operation Timing Chart, Proper Cleaning And Maintenance

AUTOMATIC FLUSH OPERATION TIMING CHART

Magnum Opus Flush and Forget® Cycle Time

Water Valve

Low Refill

Mid Refill

High Refill

Flush Valve

Opening Time

Held Open

Closing Time

0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Flush Cycle In Seconds

Additional “Add Water” Time Allowance

Magnum Opus "Add Water" Time Limits

Water Valve

Low Position

Mid Position

High Position

Service Position

0	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16
					“Add Water” Time In Seconds

PROPER CLEANING AND MAINTENANCE

The Magnum Opus toilet should be cleaned regularly for maximum sanitation and operational efficiency. You can clean it just as you would a household toilet.

Do not use caustic chemicals, such as drain-opening types, as they will damage the seals.

BOWL CLEANING: For stubborn stains, use SeaLand Bowl and Seal Cleaner (Fig. A). It’s manufactured especially for use with our Magnum Opus toilets. In certain locations where water is hard, a build-up of lime may dull the toilet bowl finish. Restore the shine with this cleaner. If you cannot find our brand in your area, contact SeaLand Product Customer Service for your nearest dealer. If it is not available, you can also use Bar Keepers Friend® cleanser. It is not necessary to vigorously scrub with either product. Please follow label instructions.

SEAL CLEANING: After an extended time, mineral deposits from hard water can build up under the edge of the rubber bowl seal, resulting in a slow leakdown of water from the bowl. To prevent this mineral build-up, periodically clean under the bowl seal with SeaLand Bowl and Seal Cleaner (Fig. B).

1.Put Mode switch in SERVICE position. Flush ball will open automatically.

2.Apply cleanser onto the seal cleaning tool (supplied with new toilet), and scrub under the seal. Make sure to push bristles between bottom of seal and top of flush ball surface to scrub all parts of seal that come into contact with flush ball.

3.Wait 2-3 minutes.

Fig. A

Fig. B

4.Pull up on flush handle to let water flow into bowl. Use cleaning tool and water to rinse away cleanser and loosened deposits. You can add water for up to 15 seconds in the SERVICE position.

5.Put Mode switch in NORMAL position. Water will flow for a few seconds, then flush ball will close automatically. Water will continue flowing into bowl, making it ready for the next flush.

5