Dometic 3000 Series owner manual Wiring Diagram, TOILET OPERATION CORRECTIVE PROCEDURES cont’d

Models: 3000 Series

1 16

Page 12

ELECTRICAL TROUBLESHOOTING (cont’d)

Symptom: Water will not enter the bowl when the Flush Handle is raised to add water.

•Place the Water Level Switch in "Low" position and flush toilet. Check status light LED 7 (Add Water) while lifting up the Flush Handle.

If LED 7 comes on, replace the Control Module.

If LED 7 remains off, the Flush Switch or its related wiring is defective.

Symptom: Water Level Switch has no effect on water level in "Low" or "High" position.

•Replace the Control Module.

Symptom: Flush Ball will not open when Mode Switch is in the "Service" position.

•Replace the Control Module.

Image 12

Contents

MAGNUM OPUS ALL-CHINAGRAVITY DISCHARGE TOILET3000 Series Toilets TABLE OF CONTENTS TOILET MODEL IDENTIFICATIONORDERING PARTS 000000IMPORTANT INFORMATION BEFORE OPERATION TOILET CONTROLSFLUSH and FORGET OPERATION OPERATING INSTRUCTIONS AUTOMATIC FLUSH OPERATION TIMING CHART PROPER CLEANING AND MAINTENANCEMagnum Opus Flush and Forget Cycle Time Magnum Opus Add Water Time LimitsDEODORANTS AND SPECIAL TISSUE WINTERIZINGSPARE PARTS DescriptionFLUSH MECHANISM COMPONENTS TROUBLESHOOTING ProblemService Instructions Possible CauseTROUBLESHOOTING cont’d MANUAL FLUSH OPERATIONELECTRICAL TROUBLESHOOTING ELECTRICAL TROUBLESHOOTING cont’d ERROR CODE CORRECTIVE PROCEDURESTOILET OPERATION CORRECTIVE PROCEDURES ConditionWIRING DIAGRAM TOILET OPERATION CORRECTIVE PROCEDURES cont’dELECTRICAL TROUBLESHOOTING cont’d CUSTOMER SERVICE Page Page EXCLUSIONS IMPLIED WARRANTIESOTHER RIGHTS Dometic Corporation Sanitation Systems