600312 & 600315 Series Installation Instructions
H.Air Distribution Box Installation
1.Remove the two return air grills and filters.
2.Slide the front end of the air box over the shafts of the thermostat and selector switch. See FIG. 13.
FIG. 13 |
Slide Air Box over Controls |
3.Install four screws through legs in air box into the
4.Install the return air grills and filters by simply push- ing them into place.
5.Install the two knobs provided on the ends of the thermostat and selector switch shafts.
6.The power supply to the air conditioner may now be turned “ON”.
7.Your air conditioner is now installed and ready for operation. Please read the following instructions be- fore attempting to run the unit.
OPERATING INSTRUCTIONS
A.Controls
1.The Selector Switch has eight positions including "OFF". This controls fan speed, heating mode, and cooling modes. See FIG. 14.
FIG. 14
Selector Switch
2.The thermostat controls the compressor ON/OFF operation in cooling temperature range of 65° to 90°F. See FIG. 15.
FIG. 15
THERMOSTAT
WARMCOOL
Note: The thermostat does not control the unit optional electric heater if installed.
B.Cooling Operation
1.Set the thermostat at the desired temperature level.
2.Select the fan speed that best satisfies your needs:
a.HIGH COOL: Selected when maximum cool- ing and dehumidification required.
b.MED COOL: Selected when normal or average cooling required.
c.LOW COOL: Selected when room at desired comfort level and needs to be maintained. Normally this speed used for night time opera- tion.
Note: The blower runs continuously to circulate air and maintain an even temperature. The compressor will come on as cooling is required to maintain the selected temperature
level.
C.Fan Operation:
1.This will circulate the air in your RV without cooling or heating. There are three positions: HIGH FAN, MED FAN or LOW FAN to select from, depending upon personal choice. See FIG.14.
D.Heating Operation: (With Optional Heat Kit
Installed)
Note: This electric heater will not replace a furnace for heating your RV in cold weather. The intent is to remove the chill on cool days or mornings.
1.Turn the selector switch to "OPT HEAT". See FIG. 14
2.The Heater will come on and begin heating.
3.When desired temperature level in RV is reached, move the selector switch to "OFF" or "FAN" posi- tion.
Note: Thermostat does not control heater ON/OFF cycle.)
E."OFF" Position
1.This is to turn Unit off.
G. Customer Maintenance
1.Periodically remove the return air filters located above the removable panels in the air box. Wash the filters with soap and warm water, let dry and the reinstall.
Note: Never run the air conditioner without return air filter in place. This may plug the unit evaporator coil with dirt and may substantially affect the performance of the unit.
2.Clean air box housing and control panel with a soft cloth dampened with a mild detergent. Never use furniture polish or scouring powders.
3.The blower motor is factory lubricated and requires no service under normal use.
8
