installation procedure
RM2451, RM2454, RM2551, RM2554, DM2652, DM2662, DM2663, DM2852, DM2862, DM3862 & NDM1062
Install the screws in the following order:
1.Two screws installed through the front base. (Installation of the lower front strip.)
The refrigerator is provided with a lower front strip
(shipped as a loose part). Attach the front strip after the refrigerator is set into the cutout opening.
a)Install the lower front strip by sliding it under the bottom hinge plate. The hinge plate can be on the right or left side depending on the door swing.
Once the lower front strip is slipped under the hinge, the part is possible to swing into place.
b)Secure the refrigerator and the lower front strip with two screws: One screw through the hinge and on the opposite side and then, one screw through the lower front strip.
2.Two screws installed in the top frame.
a)Open the door. Gently push the tabs out of the hole in the hinge
with a flat blade screwdriver |
|
(both sides). | 2 |
|
b) Carefully tilt the top decoration panel and lift to remove from
top frame. Be careful not to 1 damage the circuit board and wires.
c)Install the two screws in the top frame, the holes are accessible from underneath.
d)Seal the opening for the screws with aluminum tape.
e)Replace the top decoration panel. Be careful not to pinch the wires behind the panel. Make sure the tabs snap back into the holes in the hinge plate.
3.One screw installed in the rear base.
NDR1292
Install the screws in the following order:
1.Two screws installed through the front base. (Installation of the lower front strip.)
The refrigerator is provided with a lower front strip
(shipped as a loose part). Attach the front strip after the refrigerator is set into the cutout opening.
a)Install the lower front
strip by slid- ing it under the bottom hinge plate.
b) Secure the refrigerator and the lower front strip with two screws: One screw through each hinge.
2.Screws installed in the top frame.
a)Open the doors and remove
the four screws that secure the top decoration panel to the
top frame. Two screws are ac- cessible from underneath and two are located on each side of
the lock retainer securing the
decoration panel to the front frame. Save screws for reinstallation of the top decoration panel.
b)See step 2,
3.Two screws installed in the rear base.
- 8 -