A. Install the lower front strip by maneuvering it under the bottom hinge plates, as shown in FIG. 7.
FIG. 7 |
B. Secure the refrigerator and the lower front strip with two screws: One screw through each hinge. See FIG. 8.
FIG. 8 |
STEP 2: Install the two screws in the top frame.
A.The top decoration panel must be removed from the refrigerator before the screws can be installed. Open refrigerator and freezer doors and remove the two screws that secure decorator panel to top frame. See FIG. 9.
B.Carefully tilt the top decoration panel and lift up to remove from top frame. See FIG. 9.
FIG. 9
C. Install the second two screws in the top frame as shown in FIG. 10, and replace decoration panel, being careful to not pinch wires.
FIG. 10
STEP 3: Two screws installed in the rear base. See FIG. 11
FIG. 11
Screws
Failure to follow the sequence in securing refrigerator in the enclosure can cause leakage between the frame and cabinet.
8. GAS CONNECTION
Hook up to the gas supply line is accomplished at the manual gas shutoff valve, which is furnished with a 3/8" SAE (UNF 5/8" – 18) male flare connection. A backup wrench must be used when tightening the gas supply line. All completed connections should be checked for leaks with a noncorrosive leak detector. (See FIG. 12 – Gas
DO NOT USE A FLAME
TO CHECK FOR GAS LEAKS.
5
