OPERATING INSTRUCTIONS
CONTROLS
FIG.1
The refrigerator can be run on either 230 V, 12 V or LP gas. Changing between these modes of operation is carried out by means of the controls of the control panel shown in fig 1.
Two rocker switches are used to select the electric power supply, one for 230 V (B) and one for 12 V (A).
Refrigerator temperature is controlled by a thermostat
(C)when the unit runs on 230 V. The gas supply is turned on/off by means of the knob (D). When lighting the gas, one must press in the knob
as explained further on.
Refrigerator temperature is controlled by a thermostat
(E)when the refrigerator runs on LP gas. Please note that the thermostat has no “off” position.
In model RM 4361MD, the gas flame is electronically lit, monitored and relit if necessary. For this the toggle switch (F) should be “on” during gas operation.
An indicator lamp in the switch flashes when the automatic igniter attempts to light the burner. Otherwise this lamp is off.
STARTING THE REFRIGERATOR
The position numbers refer to fig.1.
CAUTION!
Only use one source of energy at a time!
LP Gas operation
After initial installation, servicing, or changing gas cylinders etc., the gas pipes may contain some air which should be allowed to escape by briefly turning on the refrigerator or other appliances. This will ensure that the flame lights immediately.
To start gas operation:
1.Open the
2.Check that the switches for mains and 12 V opera- tion are off.
3.Turn on the gas supply by pressing the (D) knob and turning it to the “big flame” position
4.Set the thermostat knob (E) to the highest setting.
5.Throw on switch (F). A light in the switch should now start to flash, indicating that sparks are being generated at the burner.
6.Press the (D) button. This opens the flame failure device and allows gas to flow to the burner.
7.When the flame lights, the sparking stops automa tically and the switch stops flashing.
8.Keep the (D) button pressed for a further 10 to 15 seconds to active the flame failure device, then release it.
230 V Operation
1.Turn off gas or 12 V operation when applicable.
2.Turn the knob (C) of the thermostat to its highest (coldest) position.
3.Set switch (B) to position I. The switch will light up green when the power supply is connected.
12 V Operation
Only operate your refrigerator on 12 V when the engine of the vehicle is running - otherwise your battery will soon be discharged.
1.If applicable, turn off the gas operation.
2.Set the 12 V rocker switch (A) to I. The switch will light up red when the power supply is connected.
WINTER OPERATION
Please check that the ventilation grilles or the flue outlet are not blocked by snow, leaves etc.
DOMETIC ventilation grilles can be fitted with winter covers, to protect the cooling unit against cold air. The covers may be fitted when the outside temperature is below approx. 10°C and should be fitted when the temperature is below the freezing point.
We suggest that you fit the winter covers also in the case that the vehicle is laid up during the winter months.
REGULATING THE TEMPERATURE
The position number refers to fig. 1.
It will take a few hours for the refrigerator to reach normal operating temperature. So we suggest you start it well in advance of a trip and if possible store it with precooled foodstuffs.
On 230 V operation the refrigerator is controlled by a thermostat and the thermostat knob (C) should be set at
On 12 V operation the refrigerator works continuously.
On LP gas operation the refrigerator temperature is regulated by the gas thermostat (E), which should be set at
9
