Dorel 01-068 manual To Use Using Restraint System Adjusting Harness Straps

Models: 01-068

1 12
Download 12 pages 39.02 Kb
Page 6
Image 6

7To Install Trays: (continued)

Front seat Tray: Align tubes on tray ends with holes on both sides of seat. Push in until tray locks with a snap. To remove, push both red but- tons next to tray, pull out.

Rear seat Tray: Slide tabs on tray brack- ets into slots on rear seat “armrests” as shown. Push down until tray locks with a snap.

To remove, grasp tray as shown, press tabs with thumbs to release locks, pull up and out.

To Use

8Using Restraint System:

Adjusting Harness Straps:

Shoulder

Straps

Waist

Strap

Center Button

1

3

2

To adjust shoulder straps length:

To tighten, pull out on strap end (3). To loosen, pull up top loop (1), then pull on strap (3).

3

To adjust waist strap length:

To unlock buckle, press in on center button and pull har- ness out from each side. To buckle, push each side of harness back into buckle until each clicks in place. Belt should fit snugly on child.

!WARNING: Avoid serious injury from falling or sliding out. Always use the seat belt. Check frequently to make sure it is secure.

Belts must be threaded exactly as shown. Failure to follow these instructions could result in the serious

6injury or death of your child.

2

1

4

To shorten, pull out bottom loop (2), then pull on strap end. To lengthen, pull out top loop (3), then pull out on buckle.

Page 6
Image 6
Dorel 01-068 manual To Use Using Restraint System Adjusting Harness Straps, Shoulder Straps Waist Center Button