Dorel 01-068 manual To Attach Car Seats, Put one end in first, then, compress

14To Attach Car Seats:

If you have an Eddie Bauer®, Cosco® or Safety 1st® 02-600 or 22-600 series infant car seat(s), the following instructions explain how to attach the car seat(s) to the stroller. Complete instructions for using the car seats are located on the back of the car seat.

Rear seat: Remove mounting bar from between frame beneath front seat. (Grasp red handle and push toward center of bar to release from frame.)

Place mounting bar into the two holes on the inside of stroller arms. Put one end in first, the pull in on the other end to put into second hole.

With back of stroller seat in the re- clined position, pull up on the 1-hand release handle on back of car seat and place seat rear facing into mounting bar firmly (listen for locking click).

Front seat: Place seat back in upright position. Remove mounting bar from back of front seat frame. (Grasp one end and pull back to release bar from seat frame).

Place mounting bar into the two holes	Pull up on the 1-hand release handle
on the inside of seat back as shown.	on back of car seat and place car
Put one end in first, then, compress	seat rear facing into mounting bar
bar to place other end into second	firmly (listen for locking click) until
hole. Place seat in upright position.	fully locked.

Note: When using two car seats,

1.The front stroller seat must be forward-facing.

2.Both car seats must be rear-facing.

3.Both front and rear trays must be in place when car seats are attached.

4.Make sure both car seats are locked in place before placing child in car seat.

15To Remove Car Seats:

To remove each car seat, pull up on the 1-hand release handle and lift car seat out.

!WARNING:

To avoid serious injury

•Always use tray when car seat is attached.

•Always attach car seat facing to the rear of the stroller.

•Always use the restraint system.

•Place mounting bar in storage position when not in use.

9