5716 Dremel 2.625x4.25 6/18/02 10:31 AM Page 12
Note: If the collet nut and collet are not removed from the motor shaft, the tool will not function properly.
Step 4. Install the drive adapter on the motor shaft and tighten.
4
! CAUTION | To prevent damage to tool, |
| do not over tighten drive |
|
adapter. Tighten the drive adapter finger tight and then tighten an additional 1/3 turn with the wrench. (Wrench is included with your rotary tool kit.)
12
Step 5. Screw the attachment onto your rotary tool until the coupling is tight against the housing. Hand tighten only. The attachment should be oriented on your rotary tool so that the speed control switch on the tool is easily accessible.
BLADE ASSEMBLY
Disconnect the plug of your rotary tool from the power source before making any assembly,
adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
!WARNING Always use Dremel Saw Blades. Blades that do
not match mounting hardware will run eccentrically, causing loss of control.
13
