4operation
How to Operate Your Compressor
NOTE | Before initial operation, the nebulizer cup assembly should be cleaned |
| following instructions described in the “Cleaning” section. |
WARNING | Before connecting the power cord, make sure the I/O (ON/OFF) switch is |
| in the O (OFF) position. |
| The plug is also served to disconnect the device. |
Daily Use Operation
CAUTION The Pacifica Elite Compressor is designed for intermittent use only. Do not operate it continuously for more than 30 minutes for a single use without turning it off and following a cooling period for least 30 minutes.
1.Before each use inspect the Pacifica Elite Compressor and nebulizer cup assembly for damage or wear, replace as needed.
2.Place the Pacifica Elite Compressor on a table or other flat stable surface. Be sure you can easily reach the controls when seated. Do not use this device on the floor.
3.With the power switch in the O (OFF) position, plug the power cord into an appropriate electrical wall outlet.
4.Connect one end of the tubing to the compressor
5.Assemble the nebulizer cup and add indicated medication to the nebulizer’s cup before use.
6.Attach the other end of the tubing into the
7.Turn on the Pacifica Elite Compressor by pressing the power switch to the I (ON) position and begin treatment.
8.If treatment needs to be interrupted, simply press power switch to O (OFF) position.
9.When the treatment is complete, turn off the compressor by pressing the power switch to O (OFF) position and unplug the unit from the electrical outlet.
Equipment not suitable for use in the presence of a flammable anesthetic mixture with air or with oxygen or nitrous oxide. This device has no AP or APG protection.
............................................................................................................... 9
DRIVE PACIFICA ELITE COMPRESSOR/NEBULIZER MODEL 18070
...............................................................................................................
