Dual MXDM66 owner manual Preparation, Wiring Diagram, Before You Start, Getting Started

MXDM66 INSTALLATION

Preparation

Please read entire manual before installation.

Before You Start

•Disconnect negative battery terminal. Consult a qualified technician for instructions.

•Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

MXDM66 INSTALLATION

Wiring Diagram

RCA Connections

Right Channel (Red)

Left Channel (White)

	REAR
FRONT	SUBWOOFER

FRONTSUB/W

Getting Started

•Remove trim ring from unit,

•Remove 2 transit screws located on top of the unit.

•Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.

•Install mounting sleeve into opening, bending tabs to secure.

•Connect wiring harness and antenna. Consult a qualified technician if you are unsure.

•Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).

•Test for correct operation and slide into mounting sleeve to secure.

•Snap trim ring into place.

HEX BOLT

KEYS

MOUNTING STRAP

HEX NUT

PLAIN WASHER

L-CH

R-CH

Antenna

Connector

FUSE

When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MXDM66 uses one

MOUNTING SLEEVE

TYPICAL FRONT-LOAD DIN MOUNTING METHOD

2

10 amp ATM fuse located beside the wiring connector.

3