Dual XDMA6330 owner manual General Operation, Faceplate Removal, Power On/Off Mode Auxiliary Input

XDMA6330 OPERATION

General Operation

Faceplate Removal

Semi-Permanent Faceplate Installation

Power On/Off

Mode

Auxiliary Input

Steering Wheel Interface Input

Volume

Mute

Reset

Display

Set the Clock

Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure.

Remove trim ring and install supplied #1 x 7/32” Phillips head screw through left side of mounting frame into faceplate.

Press or any other button (except eject) to turn the unit on. Inserting a disc will turn the unit on automatically. Press and hold to turn the unit off.

Press MODE to select between AM/FM, CD player, iPod, USB, auxiliary input and Bluetooth modes. Modes of operation are indicated in the display.

Note: CD mode will not appear unless a CD is inserted. USB mode will not appear unless a USB device is connected. iPod mode will not appear unless an iPod is connected. Bluetooth mode will not appear unless the BTM60 Bluetooth module is connected.

Insert 3.5 mm plug to connect your portable audio device.

The steering wheel interface input located on the back of the head unit allows connection to the PAC (Pacific Accessory Corporation) SWI-PSinterface module (sold separately). Visit www.pac-audio.com for details.

To configure steering wheel controls, follow the instructions provided with the PAC SWI-PSinterface module. After installing the interface module, insert the module's 3.5mm jack into the port on the back of the head unit.

Adjust volume using volume knob (00-46).

Press MUTE to silence the audio. “MUTE” will flash in the display. Press MUTE again to cancel.

Press to RESET the unit upon initial installation or if abnormal operation occurs. The reset button is located behind the faceplate.

Press DISP to select between clock and different types of information, such as radio frequency, CD track or MP3/USB song information.

With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISP momentarily to save the selected time.

6