Sealife DC250 Auto Power OFF, Inactivity period Camera status, Reset to Default, Description

AUTO POWER OFF

If there is no camera activity (no buttons are pressed) for a defined period of time while the camera is powered on, the camera will switch to an idle mode, and eventually turn itself off to conserve power.

Inactivity period	Inactivity period	Camera status
(batteries)	(AC power adapter)
90 seconds	90 seconds	stay idle
3 minutes	30 minutes	shut off

If the camera is idle, re-activate the camera by pressing any button or switch the
mode dial. If the camera has powered-off you must to turn the camera on again
by pressing the button. The table (above) shows the default time settings for
	E
idle, and power-off. You can change the power saving interval by using the /
button and then press the OK button.
[3 min], [5 min], [10 min], [30 min]

RESET TO DEFAULT

If you wish to restore all camera settings to their original status, select [YES] by using the / button and then press the OK button.

The following table shows the default setting for each item.

Item	Description
Image resolution	1600x1200 pixels
Image quality	Fine
Flash	Auto
Quick view	On
White balance	Auto
EV compensation	0.0
Slide show delay	4 seconds
Auto power off	Battery: 3 minutes
	AC power adapter: 30 minutes
Sound	On
Digital Zoom	Off
LCD monitor	On
	53