MUST DO for underwater housing:

1.Read these instructions before using the underwater housing.

2.Do not exceed the depth rating printed on the lens port of the housing.

3.Keep main O-Ring perfectly clean.

Clean main O-ring with cleaning brush provided before every use. Do not remove O-ring. Do not grease O-Ring.

Store camera and housing only after careful cleaning and when totally dry.

Housing uses one large O-ring at housing sealing lid. Never use housing without O-ring in place.

If O-ring is damaged, contact the SeaLife Service Center. (See page 58). Do not continue using housing

O-ring must be perfectly clean (no sand, dirt or debris) before sealing

E

housing.

 

Soak or rinse sealed housing with fresh water after use in salt water.

4.Carefully close lid to seal housing.

Make sure O-ring do not slip out of the groove when sealing.

Press lid firmly and tightly down into housing to ensure a waterproof seal.

5.Never let any moisture or dirt get inside housing when opening.

Only open and load the housing in dry cool air, such as inside an air-conditioned room.

6.For great underwater pictures you need:

Clear water conditions, control your buoyancy before taking picture, get as close as possible to subject (ideal distance is 2’ to 6’). Use the SeaLife Macro Lens/Filter for close-up pictures with super details and vibrant colors.

7.Store housing at room temperature in a clean and dry place

Do not expose housing to direct sunlight for prolonged periods of time.

Do not store housing in hot locations, like the trunk of your car.

57

Page 57
Image 57
Sealife DC250 manual Must do for underwater housing