XDMA6630 INSTALLATION

Preparation

Please read entire manual before installation.

Before You Start

Disconnect negative battery terminal. Consult a qualified technician for instructions.

Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

Remove trim ring from unit,

Remove 2 transit screws located on top of the unit.

Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.

Install mounting sleeve into opening, bending tabs to secure.

Connect wiring harness and

antenna. Consult a qualified technician if you are unsure.

• Certain vehicles may require an KEYS installation kit and/or wiring

harness adapter (sold separately).

Test for correct operation and slide into mounting sleeve to secure.

Snap trim ring into place.

HEX NUT

HEX BOLT

PLAIN WASHER

MOUNTING SLEEVE

TYPICAL FRONT-LOAD DIN MOUNTING METHOD

2

Page 2
Image 2
Dual XDMA6630 owner manual Preparation, Before You Start, Getting Started