XDVD8130 OPERATION
Troubleshooting
Problem | Cause | Action |
Unit will not turn on | Yellow wire not connected or incorrect voltage | Check connections for proper voltage |
(no power) | Red wire not connected or incorrect voltage | (11~16VDC) |
|
|
|
| Black wire not connected | Check connection to ground |
|
|
|
| Fuse blown | Replace fuse |
|
|
|
Unit has power | Speaker wires not connected | Check connections at speakers |
(but no sound) | One or more speaker wires touching each other | Insulate all bare speaker wires from each |
| ||
| or touching chassis ground | other and chassis ground |
|
|
|
Unit blows fuse | Yellow or red wire touching chassis ground | Check for pinched wire |
| Speaker wires touching chassis ground | Check for pinched wire |
| Incorrect fuse rating | Use fuse with correct rating |
|
|
|
Unit has audio | Parking brake safety circuit not connected | Check connections at parking brake |
(but no video) | Parking brake not applied | Apply parking brake |
No subwoofer output or | Subwoofer mode is not active | Activate subwoofer mode - see page 11 |
low subwoofer output | Subwoofer output level is turned down | Increase subwoofer output level |
No V3 video display | Reverse circuit not connected | Check connections at reverse lamp |
(when in reverse) | Vehicle is not in reverse | Select reverse gear |
IR remote does not work | Dead batteries | Replace batteries |
| Remote set to control wrong model | Select XDVD8130 - see page 9 |
Excessive skipping | Unit is not mounted correctly or backstrap is | Check mounting sleeve and backstrap |
| not secure | support |
|
|
|
| Physical defect in media | Check media for scratches |
Disc mechanism error | Press eject or RESET | |
on display |
|
|
|
|
|
Focus error or disc is in upside down | Press eject or RESET | |
on display |
|
|
Region code error | Use only DVDs labeled “Region 1” or | |
on display |
| “All” only |
Unit will not accept | Disc mechanism position out of alignment | Press EJECT for 3 seconds to reset |
a disc |
| disc mechanism position |
|
|
|
| Disc mechanism transit screws still in place | Remove 2 transit screws located on top |
|
| of the unit |
|
|
|
Copyright Notes
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Manufactured under license from Dolby Laboratories. “Dolby” and the
Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft Corporation in the United States and or other countries.
30