Dual XDVD8285 Preparation

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.

• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it

would be subject to dust, dirt or excessive vibration.

Getting Started

• Insert the supplied keys between the radio and the sleeve at the left and right sides, and slide the unit out of the

mounting sleeve.

Mounting Options

1. Rear ISO-DIN (using OEM factory radio mounting brackets):

• Remove factory radio mounting brackets and attach to the left and right sides of the XDVD8285 chassis.

• See diagram below.

2. Front load (using mounting sleeve):

• Install mounting sleeve into opening, bending tabs to secure.

• Connect wiring harness and antenna as shown on pages 6-7. Consult a qualified technician if you are unsure.

• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).

• Test for correct operation and mount according your application.

• If required, snap desired trim ring into place.

• Mount the iplug™ adapter to any smooth clean surface using the supplied double-sided tape or Phillips head

screws.

Preparation

Mounting the XDVD8285 using OEM factory

mounting brackets.

Mounting the XDVD8285 using mounting

sleeve (front load).