Panasonic KX-TDA100 installation manual Problem, Probable Cause, Solution

4.1.3 Operation

PROBLEM

•The LED of the CS stays Red ON during normal operation.

•"CLEAR SCAN DATA" is displayed on the PS’s screen after turning on the PS.

•Cannot register the PS.

•PS becomes out of range.

•Cannot make calls using the PS.

•Noise is frequent while using the PS.

•Conversations disconnect while using the PS.

•"NO SERVICE" is displayed on the PS’s screen.

•The CS is not busy (i.e., the status of the LED is not Moderate Green Flashing), but calls cannot be made or received.

•There is noise during a phone call.

PROBABLE CAUSE

•CS malfunction

•The PS cannot be used for normal operation when scan data is stored on the PS.

•Wrong Personal Identification Number (PIN) is registered to the PS.

•CS is not connected properly.

•CSIF card is not working.

•CS is not working.

•Location of CS is not good.

•Access system of the PS is not properly set.

•Call handover is not working.

•PS is out of CS coverage area.

•CSs are located too close together in the same area.

SOLUTION

•Replace the CS.

•Clear the scan data (refer to "2.8.5 Site Survey Using the KX-TCA255/KX-TCA256/KX-TCA355/KX-TD7590"or "2.10.5 Site Survey").

•Enter the PIN set to the PBX into the PS.

•Make sure that the cable is connected properly with correct pin assignments. Also, make sure that the cable does not make short circuits.

•Switch all DIP switches off.

•Install the CSIF card properly.

•Make sure that the cable is connected properly with correct pin assignments. Also, make sure that the cable does not make short circuits.

•Switch all DIP switches off.

•Locate the CS properly (refer to "2.8.5 Site Survey Using the KX-TCA255/KX-TCA256/KX-TCA355/KX-TD7590", "2.9.5 Site Survey",

or "2.10.5 Site Survey").

•Change the access system setting of the PS to the appropriate system or automatic.

•Locate the CS properly (refer to "2.8.5 Site Survey Using the KX-TCA255/KX-TCA256/KX-TCA355/KX-TD7590", "2.9.5 Site Survey",

or "2.10.5 Site Survey").

•Reduce the number of CSs in the area, or increase the distance between CSs (refer to "2.8.5 Site Survey Using the KX-TCA255/KX-TCA256/KX-TCA355/KX-TD7590", "2.9.5 Site Survey",

or "2.10.5 Site Survey").

264

Installation Manual