Panasonic KX-TDA100 Confirming the Trunk Connection, LED Indications, Colour, Description

2.14.1Starting the PBX

2.Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will flash.

Note

For safety reasons, do not stretch, bend, or pinch the AC power cord.

To AC Outlet

3.While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position. Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the RUN indicator will stop flashing and stay lit.

All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW card) will be initialised to the default values. The DPTs should show the time as 01:00.

The data of the IP-GW card will not be initialised.

LED Indications

Indication

RUN

ALARM

Colour

Green

Red

Description

PBX status indication

•OFF: Power Off (includes normal reset)

•ON: Power On and running (on-line)

•Flashing (60 times per minute): Starting up

•Flashing (120 times per minute): Starting up or resetting with:

•the System Initialise Switch in "SYSTEM INITIALIZE" position

•the SD Memory Card not inserted

Alarm indication

•OFF: Normal

•ON: Alarm (CPU stop, alarm for each optional service card installed in the Basic Shelf)

•Flashing: Alarm (MPR file error in restarting)

Confirming the Trunk Connection

After initialisation, programme the PBX and connect trunks to the PBX.

To confirm that the trunks are successfully connected, dial [] [3] [7] + trunk number (3 digits) on a PT, or press the PT's S-CO button. You will hear a dial tone if the trunk is available and connected.

250

Installation Manual