Panasonic KX-TDA100 installation manual Starting the PBX, System Initialisation Procedure

2.14.1 Starting the PBX

2.14 Starting the PBX

2.14.1 Starting the PBX

CAUTION

•Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing an earthing strap.

•Once you have started the PBX and if you unplug the PBX, do not perform the following procedures to start the PBX again. Otherwise, your programmed data is cleared. To restart the PBX, refer

to "4.1.4 Using the Reset Button".

•The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located near the equipment and is easily accessible.

•Use only the AC power cord included with the PBX for the PSU.

Notice

The SD Memory Card must be inserted in the SD Memory Card slot of the MPR card before startup.

Note

The PBX will continue to be powered even if the power switch is turned "OFF".

System Initialisation Procedure

1.Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.

RUN Indicator

Reset Button

RESET

SYSTEM

INITIALIZE

NORMAL

System Initialise Switch

Installation Manual

249