4Loosen the two captive screws that attach the lamp housing to the pro- jector.
5Detach the lamp connector from the projector by depressing the locking tab on the connector and lightly pulling it free.
WARNING:
To avoid burns, allow the projector to cool for at least 30 minutes before you replace the lamp.
Do not drop the lamp housing or touch the glass bulb! The glass may shatter and cause injury.
Be extremely careful when removing the lamp housing. In the unlikely event that the bulb ruptures, small glass fragments may be generated. The lamp housing is designed to contain these frag- ments, but use caution when removing the lamp housing.
lamp connector
lamp cable
lamp
housing
screw
6 Carefully remove the lamp housing. Dispose of the lamp in an environ- |
mentally proper manner. |
connector
lamp cable
7 | Install the new lamp housing and tighten the screws. |
8 | |
| engage when the connector is fully plugged in. |
9 | Replace the lamp door. |
10Plug in the power cord and toggle the Power switch to turn the projector back on.
11To reset the lamp hour timer, navigate to the Settings>Service menu and select Lamp Reset. See page 35 for details.
locking tab 
lamp housing
screw
Service menu
37
