1. Introduction

Top Features

10

4

5 11

9

M

EN

U

 

 

 

SELECT

E

 

 

 

N

 

 

IT

T

 

X

 

E

R

 

 

E

PC CARD

SOURCE

AUTO ADJUST

LAMP

2

STATUS

3D REFORM ON/STAND BY POWER

6 7 8 12 1 3

1.POWER Button (ON / STAND BY)

Use this button to turn the power on and off when the main power is supplied and the projector is in standby mode.

NOTE: To turn on the projector, press and hold this button for a minimum of two seconds. To turn off the projector, press this button twice.

2.STATUS Indicator

If this light blinks red rapidly, it indicates that an error has occurred, the lamp cover is not attached properly or the projector has overheated. If this light remains orange, it indicates that you have pressed a cabinet key while the Cabinet Button Lock is enabled. See the Status Indicator section on page 123 for more details.

3.POWER Indicator ( )

When this indicator is green, the projector is on; when this indicator is orange, it is in standby mode. See the Power Indicator section on page 123 for more details.

4.SOURCE Button

Use this button to select a video source such as a PC, VCR, DVD player or Viewer (PC card).

Press and release this button quickly to display the Source List.

Each time this button is pressed for a minimum of ONE second, the input source will change as follows:

Computer1 → Computer2 → Video → S-Video → Viewer → Computer1 → ...If no input signal is present, the input will be skipped.5.AUTO ADJUST ButtonUse this button to adjust an RGB source for an opti- mal picture (See page 35).
6.PC CARD Access Indicator Lights while accessing a PC card.7.ENTER ButtonExecutes your menu selection and activates items selected from the menu.8.EXIT ButtonPressing this button will return to the previous menu with saving changes.While you are in the main menu, pressing this button will close the menu.9.SELECT ￿￿￿￿ (+) (–) / Volume Buttons￿￿: Use these buttons to select the menu of the item you wish to adjust.

￿￿: Use these buttons to change the level of a selected menu item. When no menus appear, these buttons work as a volume control.

When the pointer is displayed, these ￿￿￿￿ buttons move the pointer.10.MENU Button Displays the menu.11.LAMP Indicator

If this light blinks red rapidly, it's warning you that the projection lamp has exceeded 2000 hours (up to 4000 hours in Eco mode) of service. After this light appears, replace the lamp as soon as possible. (See page 119). If this is lit green continually, it indicates that the lamp mode is set to Eco. See the Lamp Indicator section on page 123 for more details.

12.3D REFORM Button

Press this button to enter 3D Reform mode to correct the keystone (trapezoidal) distortion, and make the image square.

7