3. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one of the 8 menu languages.
To select a menu language, follow these steps:
1.Use the SELECT or button to select one of the 8 languages for the menu.
LAMP |
|
|
STATUS |
|
|
POWER | VIDEO |
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu opera- tion.
If you want, you can select the menu language later. See "Lan- guage" on pages 38 and 44.
SELECT
ON/STAND BY
AUTO
ADJ.
8767A/8070 8771
OFF | ON |
|
|
|
POWER |
|
|
|
|
MAGNIFY | PAGE |
|
|
|
| UP |
|
|
|
|
|
| SELECT | |
| DOWN |
|
|
|
MENU |
|
|
|
|
ENTER | EXIT |
| SOURCE | |
| LAMP |
|
|
|
| STATUS |
|
|
|
| POWER | VIDEO | ||
SELECT
ON/STAND BY
AUTO
ADJ.
8767A/8070 8771
OFFON
POWER
MAGNIFY
UP
SELECT
DOWN
MENU
ENTER | EXIT | SOURCE |
NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
When the Lamp mode is set to Eco, the LAMP indicator will light green.
If one of the following things happens, the projector will not turn on.
•If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal components to cool down.
•When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
•If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and then turn on the power.
24
