Dukane 8755E-RJ, 8776-RJ user manual RJ Only

Ports (See below.)

CB/PB
CR/PR			RGB IN1
VID	A	A
EO	UDIOUDIO IN1
S-VI			IN2	RGB IN2
DEO							LAN
				CO	NTR	RGB	OUT
							A
					OL		UDIO
						USB	OUT

Rear-Left side

Part names

Power switch (17)

AC inlet (14)

Elevator button (9)

AC IN

Elevator foot (9)

Vent

			AUDIO IN1 port (12)
			(In the default setting, the AUDIO IN1 port is the audio
AUDIO IN3 L/R port (13)			port for the RGB IN1 port, however, it is possible to
			change the settings. 36)
(In the default setting, the
AUDIO IN3 L/R port is the audio				RGB IN1 port (12)
port for the VIDEO, S-VIDEO
and COMPONENT VIDEO					Restart switch (*) (62)
ports, however it is possible to						RJ Only
change the settings. 36)					RGB IN2 port (12)
						LAN port (12)
COMPONENT					LAN	Used for Ethernet
	Y R					input/output.
VIDEO ports (13)						This port is used
		AUDIO IN3
Y				RGB IN1	RGB IN2 RGB OUT AUDIO OUT	when utilizing
CB/PB	CB/PB	L		AUDIO IN1		network functions.
CR/PR			AUDIO IN2
	CR/PR				USB	AUDIO OUT port
				K
VIDEO port (13)					CONTROL	(12)
	VIDEO
	S-VIDEO					Ports
S-VIDEO port (13)
					RGB OUT port (12)
AUDIO IN2 port (12)
					USB port (12)
(In the default setting, the AUDIO
IN2 port is the audio port for					CONTROL port (12)
the RGB IN2 port, however, it is
possible to change the settings.				Kensington lock slot
36)

NOTE (*) About Restart switch: This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.