Connecting the Optional Power Adapter
An optional 9 Volt, 1.5 A power adapter can also be used to power the label maker. Connecting the AC adapter to the label maker disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top, left side of the label maker.
Figure 3
2.Plug the other end of the power adapter into a power outlet.
ÇMake sure the label maker power is turned off
before you disconnect the power adapter from the main power source. Otherwise, your most recent memory settings will be lost.
Inserting the Tape Cassette | Guideposts | ||
Your label maker comes with one tape cassette. Visit |
| Remove | |
www.dymo.com for information about |
| cardboard insert | |
| Figure 4 | ||
purchasing additional tape cassettes. |
| ||
|
| ||
To insert the tape cassette |
|
| |
1. | Lift the tape cassette cover to open the tape |
|
|
| compartment. See Figure 3. |
| Click! |
| Ç Before using the label maker for the first time, |
|
|
| remove the protective cardboard insert from the tape |
| |
| exit slot. See Figure 4. |
|
|
2. | Insert the cassette with the label facing up and |
|
|
| positioned between the guideposts. |
| Click! |
3. | Press firmly until cassette clicks into place. See Figure 5. | Figure 5 | |
4. | Close the tape cassette cover. |
|
|
6
