Technical Specifications
NOT LEGAL FOR TRADE
Model | M10 | M25 |
|
|
|
Capacity | 10 pounds (4.5 kg) | 25 pounds (11 kg) |
|
|
|
Weight Increments | 0.1 oz (2 g) | 0.1 oz (2 g) |
|
|
|
Accuracy | ±0.2 oz | ±0.2 oz |
Under half the capacity | ||
Over half the capacity | ±0.4 oz | ±0.4 oz |
|
|
|
Units | lb/oz (kg/g) | kg/g (lb/oz) |
|
|
|
Auto Shut Off | After three minutes of inactivity |
|
|
|
|
Operating Temperature | 50° - 104° F (10° - 40° C) |
|
|
| |
Interface | USB 2.0 Low Speed HID Scale Device | |
|
|
|
Power | USB or 3 AAA alkaline batteries |
|
|
|
|
For information about our other scale products, visit www.dymo.com.
Troubleshooting
Problem/Error Message
No display
LO is displayed
Negative number is displayed
00000 is displayed
Display reads 0.0 with an item on the platform
Solution
Ensure the scale is plugged in, or replace the batteries.
Replace the batteries.
A tare value is displayed as a negative number when the items
are removed from the scale. Press | 0.0 | to reset the scale to zero. |
TARE | ||
|
|
|
The item on the scale platform exceeds the maximum capacity of the scale. Remove the item immediately to prevent damage to the scale.
This can happen because:
• The Tare/Zero button, | 0.0 | , was pressed while an item was on |
TARE | ||
|
|
|
the scale.
•Power to the scale was disconnected or turned off and then on again with an item on the scale.
In both of these cases, remove the item from the platform and
press | 0.0 | to return the display to 0.0. |
TARE | ||
|
|
|
If you need further assistance, contact Technical Support at (877)
4