Dynacord manual CXM 15 / CXM 15W, Coaxial Monitor Speaker Cabinet, Under Iris-Net

CXM 15 / CXM 15W

CXM 15 / CXM 15W

COAXIAL MONITOR SPEAKER CABINET

•Coaxial Monitor 15“ / 1.4“ 2-Way

•102 dB SPL / 1 W / 1m

•Max. 135 dB SPL / 1 m

•Light Weight 19 kg

•Switchable to Biamp Mode

•FIR and IIR Presets available

The DYNACORD CXM 15 is a lightweight wedge for professional monitoring applications. The DYNACORD DCX15450 two-way 15“ / 1.4“ transducer uses a coaxially mounted HF unit and can be used in passive or bi-amped operating mode.

The acoustic crossover frequency between the 15“ low-frequency transducer and the 1.4“ mid-high compression driver is at 1.2 kHz. The slope of the built-in passive cross- over network is 12 dB / octave. Extremely precise vocal definition is assured by the comparatively low crossover frequency and the coaxial transducer design. Power amplifiers are connected to the CXM 15 via Speakon NL4MPR

connectors. The pin assignment in passive mode is 1+ / 1-. Switching from passive mode to bi-amped mode is performed by operation of

aslider switch. In bi-amping mode, pins 1+ / 1- are connected to the 15“ low frequency section of the CXM 15 and pins 2+ / 2- to the 1.4“ mid-high-frequency section.

The CXM 15 is equipped with three Speakon sockets switched in parallel. This simplifies the daisy-chaining of multiple wedges and pole-mounted CXM 15 cabinets. The 1.4“ MF/HF compression driver is safeguarded against thermal overload by the fully-electronic Voice Coil Tracking Protection system, which exhibits „soft“ switching characteristics, sparing audiences the annoying

clicks and pops that are the bugbear of conventional solutions. Both FIR and IIR presets are available for a wide variety of operating modes. The CXM 15 is constructed from birch plywood and therefore extremely resistant to abuse on the road. All cabinet connections are slotted and glued. The surface is protected by a hard-wearing textured finish.

Apowder-coated steel grille backed by acoustic foam protects the loudspeaker components from ac- cidental damage. A recessed adapter is provided to facilitate pole-moun- ting. Handles have been integrated into both sides of the CXM 15.

Aversion of the CXM 15 in white is also available: the CXM 15W.

OPTIMIZED FACTORY PRESETS INCLUDING FIR-TUNE LINEARIZATION ARE AVAILABLE FOR DSP 600, P 64 AND PowerH AMPLIFIERS WITH RCM-26

UNDER IRIS-NET.

64