Dynasty Spas 2007 manual Trouble Shooting Guide, No heat or heat too low, Spa Lights wont come on

Models: 2007

1 28
Download 28 pages 24.17 Kb
Page 23
Image 23
TROUBLE SHOOTING GUIDE

TROUBLE SHOOTING GUIDE

No heat or heat too low

Probable Cause #1

Dirty Filter.

Action

Remove filter cartridge and clean.

Probable Cause #2

Breaker at house off.

Action

Reset breaker at house. Breaker can appear to be on

 

and one pole can be off. Turn breaker OFF then ON

 

twice.

Probable Cause #3

Pump not primed.

Action

Refer to the section of this manual on pump priming.

Probable Cause #4

Improper line voltage.

Action

Have a Licensed Electrician check the line voltage.

Spa Lights won't come on

Probable Cause #1

Light bulb burned out.

Action

Replace bulb (non-warranty).

Probable Cause #2

Dirty connection.

Action

Check to see if there is anything covering the

Pump will not prime

connection on the housing that holds the light bulb.

 

Probable Cause #1

No water in pump.

Action

Make sure water level in spa is correct.

Probable Cause #2

Closed gate valves or blocked lines.

Action

Open all gate valves. Check suction for blockage.

Probable Cause #3

Pump surges, jets lose and gain power, loose union

 

or drain plug.

Action

Check union on front or nose of pump to ensure

Jet(s) won't come on

tightness. Check drain plugs to ensure tightness.

 

Probable Cause #1

Pump not primed.

Action

Refer to the section of this manual on pump priming.

Probable Cause #2

Gates valves closed.

Action

Check to see if gate valves are in the correct position.

 

Check to see that pump is plugged in.

Probable Cause #3

Water Diverter Valve not adjusted correctly.

Action

Turn Water Diverter Valve until desired water flow is

 

obtained.

Probably Cause #4

Individual jet is closed.

Action

Turn the outer jet housing clockwise to turn jet on.

Low water flow

 

Probable Cause #1

Dirty Filter.

Action

Remove filter cartridge and clean.

Probable Cause #2

Closed gate valves or blocked lines.

Action

Open all gate valves.

Probable Cause #3

Low voltage or incorrect voltage.

Action

Have a Licensed Electrician check the line voltage.

Dynasty Spas Operator’s Guide • www.dynastyspas.com

23

Page 23
Image 23
Dynasty Spas 2007 manual Trouble Shooting Guide, No heat or heat too low, Spa Lights wont come on, Pump will not prime