Dynaudio SUB 600 owner manual Controls and connections, Before Operation, Dynaudio Sub

BEFORE OPERATION

		➋
	POWER	GAIN	PHASE
➊	ON AUTO		0° 180°
		Min	Max
	SAT Highpass	SUB Lowpass

Controls and connections

➊POWER

Subwoofer auto power mode:

•ON = Auto mode disabled (subwoofer is switched on permanently, when main

➌power switch is set to ON).

•AUTO = Auto mode enabeld (when main power switch is set to ON and a music

➎

signal is detected, the internal amplifier is activated automatically).

		50 Hz	150 Hz
		SAT/SUB Input	SAT Output
	LEFT
➏
	RIGHT
		LFE / Slave IN	OUT
➐	SUB I/O		To Slave
➑	LFE	Slave
			100-120V/220-240V
			~ 50/60Hz 3.15A

ON

➒

OFF

FUSE T3.15A L 250V

➋ GAIN

Subwoofer volume level.

➌PHASE

Phase setting: phase can be set to 0° or 180°.

➍SAT Highpass

Allows cutting off low frequencies of the signal provided at the SAT Output:

•Flat = signal is not processed

•60 = cut-off frequency at 60 Hz

•80 = cut-off frequency at 80 Hz

➎SUB Lowpass

Subwoofer lowpass frequency: continuously variable from 50 to 150 Hz.

➏SAT/SUB Input, SAT Output

•SAT/SUB Input: Input for full bandwidth signal from processor/receiver. This signal will be processed according to the SAT Highpass setting and provided at the SAT Output connection for satellite speakers to be connected.

➓• SAT Output: Output for satellite speakers to be connected. This signal is processed according to the SAT Highpass setting.

8 Dynaudio Sub 600