Dynaudio SUB 600 owner manual Specific tips, Damage of Small Satellite Speakers, Dynaudio Sub

OPTIMIZING SETTINGS/TROUBLESHOOTING

Specific tips

Many processors/receivers provide extensive bass management capabilities to set the cut-off frequencies for both subwoofer and speakers. If using the bass management of the processor/receiver, set the controls of the Sub 600 as followed:

•SUB Lowpass = 150 Hz (at the very right)

•SAT Highpass = Flat

	CAUTION	Damage of Small Satellite Speakers
		Selecting the correct frequency depends to a large extend on the main speakers.
		Sometimes main speakers are specifically intended to work with a subwoofer. In such
		cases, the main speakers can get damaged by a full-range amplifier signal.
		 If in doubt, check the instruction manual for the main speakers for any restrictions.
		The table below offers some setting tips for different speaker and amplifier combinations.
		This should only be taken as rough guidelines, as the best setup can just be found by
		experimenting.
Speaker/amplifier	Recommended first setting		If you experience	...try this
			this problem
	SUB Lowpass	SAT Highpass	after first setting...
Large speaker,	50 Hz	Flat	bass too bloated	Decrease volume (GAIN),
powerful amplifier				SAT Highpass = 60 Hz
			bass too weak	Increase volume (GAIN),
				Increase SUB Lowpass step wise
Large speaker,	50 Hz	60 Hz	bass too bloated	Decrease volume (GAIN),
weaker amplifier				SAT Highpass = 80 Hz
			bass too weak	Increase volume (GAIN),
				Increase SUB Lowpass step wise

28 Dynaudio Sub 600