Maintenance |
General
Problem | Solution |
|
|
One or more channels do | • Make sure that the channels are |
not display. | not blocked. For more |
| information, see “Setting parental |
| |
|
|
Password is lost. | • Enter 9999 to access parental |
| controls, then set a new |
| password. For more information, |
| see “Setting parental controls” on |
| page 14. |
|
|
Some settings cannot be | • If a setting is grayed, the setting is |
accessed. | not available in the current video |
| input mode. |
|
|
TV cabinet creaks. | • When the TV is in use, the |
| temperature rises naturally and |
| may cause the cabinet to expand |
| or contract which can cause a |
| creaking noise. This is not a |
| malfunction. |
|
|
Control buttons on the TV | • Disconnect the power cord, wait a |
do not work. | few seconds, then reconnect the |
| power cord and turn on the TV. |
|
|
Note: If the problem is not solved by using these troubleshooting instructions, try turning off your TV, then turning it on again.
Maintenance
Just like with any other household appliance, the performance and
Cautions:
•Make sure that the TV is turned off and the power cord is disconnected from the power outlet before cleaning the TV.
•Never spray or pour any liquid directly onto the screen or the case.
Cleaning
•Clean your TV with a soft, dry cloth. If surfaces are extremely dirty, use a soft cloth dampened with a small amount of
•Clean the screen with a clean, soft,
Specifications
Specifications subject to change without notice.
Weight and dimensions shown are approximate.
TV type | LCD |
TV panel | |
TV system | |
|
|
Receiving channels | VHF: 2 - 13 |
| UHF: 14 - 69 |
| CATV: 1 - 125 |
| CADTV: |
| DTV: |
Audio multiples | BTSC system |
|
|
Audio out | 10 W x 2 |
|
|
Power requirement | AC 120 V, 60 Hz |
Power consumption | 285 W |
|
|
Dimensions | 51.97 × 34.65 × 16.14 inches |
(W × H × D with stand) | (1320 × 880 × 410 mm) |
|
|
Weight | 100.33 lbs. (45.5 kg) |
|
|
Input terminals | Composite video/L and R audio (2) |
| Component video/L and R audio (2) |
| HDMI (4) |
| VGA and PC/DVI audio (1) |
| ANT/Cable (1) |
|
|
Output terminals | Digital Coaxial Audio (1) |
| Headphone (1) |
| L/R Audio (1) |
|
|
Control terminals | SERVICE PORT (1) |
Legal notices
FCC Part 15This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced technician for help.
FCC warningChanges or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user’s authority to operate this equipment.