
4 | TV components |
3Align the base with the TV, then secure the stand to the TV with the six screws (M6 x 12) provided.
Baseplate
4Carefully lift the TV into an upright position. To remove the stand, see the following procedure.
Removing the stand
You must remove the stand before you can
Note: Your TV may differ from the illustrations shown.
To remove the stand:
1Lay the TV (screen down) on the edge of the table or bench. Make sure that you put a soft cloth or cushion between the table or bench and the TV.
2Remove the six screws holding the stand to the TV, then remove the stand.
Installing a wall-mount bracket
If you want to attach the TV to a
Warning: These instructions are for use by qualified service person only. To reduce the risk of hazards, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.
To install a wall-mount bracket:
1Lay your TV face down on a table or bench. Make sure that you put down a soft cushion or cloth so that your TV is not scratched.
2Remove the pedestal stand. See “Removing the stand” above.
3Secure the
TV components
Front and side controls
Item | Name |
| Description | |
|
|
|
| |
1 | MENU | Press to open the | ||
|
|
|
| |
| INPUT | Press to open the INPUT SOURCE menu. | ||
2 |
|
|
| For more information, see “Selecting the |
|
|
|
| video input source” on page 11. |
|
|
|
|
|
| VOL | / VOL | In TV mode, press to increase or decrease | |
3 |
|
|
| the volume. |
|
|
| In menu mode, press to move right or left or | |
|
|
|
| |
|
|
|
| to adjust menu settings. |
|
|
|
|
|
| CH | /CH | In TV mode, press to select the next or | |
4 |
|
|
| previous channel. |
|
|
|
| In menu mode, press to move up or down. |
|
|
|
| |
|
| (power) | Press to turn on the TV or put the TV in | |
|
| |||
|
| |||
5 |
|
|
| standby mode. |
|
|
| Caution: The TV continues to receive power | |
|
|
|
| even in standby mode. Unplug the power |
|
|
|
| cord to disconnect power. |
|
|
|
| |
6 | Power indicator | Lights red when your TV is in standby mode. | ||
|
|
| Turns off when the TV is on. | |
|
|
|
| |
|
|
|
| |
| Remote control | Receives signals from the remote control. | ||
7 | sensor | Do not block. For more information, see | ||
|
|
|
| “Aiming the remote control” on page 7. |
|
|
|
|
|