Dynex DX-LCD32-09 manual I am missing channels

I am missing channels.

oIt is possible that the Favorite button was pressed accidentally.

ƒPress the Favorite button on the remote.

oMake sure the channel is not blocked by Parental Controls.

oAre you using a cable/satellite box, cable connected directly to the TV, or an antenna?

ƒIf you are using a cable or satellite box you must use the remote that came with that box to change channels.

•Make sure you have the correct input selected to view channels via the cable or satellite box. For example, if the cable or satellite box is connected via component cables please press input and select Component 1 or Component 2 to view your channels.

•Reception can vary by channel depending on the broadcast power level of a given station. Contact your cable or satellite provider.

ƒIf you are using cable connected directly to the TV:

•Try running an autochannel search:

oPress MENU. The on-screen menu opens.

oPress < or > to select Channel, then press v to access the Channel menu.

oPress ^ or v to select Air/Cable, then press < or > to select Cable.

oPress ^ or v to select Auto Scan. Press > or ENTER.

oPress ^ or v to select Cable System, then press < or > to select your type of cable or satellite system. You can select STD, IRC, HRC, or AUTO. If you are not sure what type of system you have, select AUTO.

oPress ^ or v to select Start to Scan, then press > or ENTER to start scanning. Your TV memorizes all cable channels you receive.

•Reception can vary by channel depending on the broadcast power level of a given station. Contact your cable provider.

ƒIf you are using an antenna:

•Try running an autochannel search:

oPress MENU. The on-screen menu opens.

oPress < or > to select Channel, then press v to access the Channel menu.

oPress ^ or v to select Air/Cable, then press < or > to select Air.

oPress ^ or v to select Auto Scan. Press > or ENTER.

oPress ^ or v to select Start to Scan, then press > or ENTER to start scanning. Your TV memorizes all analog and digital channels you receive.

•The signal strength of the channel may be low.

oCheck the signal strength of the channel by pressing the Display button on the remote. The signal strength is displayed in the lower right corner of the Display screen.

•If the signal level is Weak:

•Make sure your antenna is connected securely to the TV.

•Move the antenna around the room or close to a window.

•Use a basic indoor set-top antenna designed to pick up both VHF and

UHF.

OR

Use a set-top antenna that has a built-in signal amplifier.

OR

Use an antenna mounted on your roof or in your attic

•For more information about antennas and the available channels in

your area, visit www.antennaweb.org

oThe UHF band (channels 14 and higher) is more directional than VHF (channels 2-13) and more sensitive to obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and the broadcast tower. Getting good UHF reception can be more difficult than VHF.

oIf you're getting marginal reception of digital signals, both the picture and sound might freeze or break up to the point that it's not watchable. If you're really on the fringes—either too far from a tower or with too many obstacles in the way—you'll see a black screen that says "No signal."

oReception can vary by channel, depending on the location and broadcast power level of a given station.

4