Installation instructions 5

DX-TVM112
STEP 2 - Option 1: Installing on a wood stud wall
Note: Any wallboard or material covering the wall must not exceed 5/8" (16 mm).
1Locate the stud. Verify the center of the stud* with an edge-to-edge stud finder.
2Align the wall plate (A) at the height you determined in the previous step and make sure that it is level. Use a
pencil to mark the lag bolt hole locations (2) on the stud centers. Remove the wall plate.
3Drill pilot holes to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit.
4Align the wall plate (A) with the pilot holes, insert the lag bolts (N) through the lag bolt washers (M), then
through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.
CAUTION: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (N).
You’ll need
3 in.
(75 mm)
* Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (11/2 x 31/2 in.).
Edge-to edge
stud finder
N (2)
Pencil
Drill
7/32" wood
drill bit 1/2" socket wrench
Level
Wall plate (A)
M (2)
DX-TVM112_12-1056_MAN_V1_EN.fm Page 5 Sunday, November 25, 2012 6:55 PM