Dynex DX-TVM113 10 , Youl l need

10 Installation instructionsDX-TVM113

STEP 5 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed

backs

1Align the left and right TV brackets (B and C) with the screw holes on the back of the TV. Make sure that the

brackets are level.

2Place spacers (H or N) behind the TV brackets. If you are using M4 washers (F), place them between the

spacers and TV brackets and over the holes in the TV brackets. If you are using M6 washers (G), place them

over the holes in the TV brackets. Insert screws (E, K, or M) through the washers, TV brackets, and spacers.

3Tighten the screws until they are snug against the TV brackets. Do not over tighten.

You’l l need

or

or

or

or

E

F (8)

E (4)

Phillips screwdriver

Screws Washers Spacers

H (4)

B and C TV brackets

G (4)

K (4)

or

or

or or

N (4)

M (4)

Level

DX-TVM113_13-0321_MAN_V2_EN.fm Page 10 Friday, April 26, 2013 11:11 AM

Contents

Main DX-TVM113 Slim-Profile TV Wall Mount ASSEMBLY GUIDE 2 Safety information and specifications Tools needed Package contents 3 DX-TVM113 ABCR Package contents TV Hardware Bag Installation instructions STEP 1 - Determine wall-mount location Youl l n eed Installation instructions 5 STEP 2 - Option 1: Installing on a wood stud* wall Note: Any drywall covering the wall must not exceed 5/8" (16 mm). R CA UTIO N: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (P). STEP 2 - Option 2: Installing on a solid concrete* or concrete block wall CA UTI ON: directly onto the concrete surface. CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (P). STEP 3 - Determine whether your TV has a flat back or an irregular or obstructed back STEP 4 - Select screws, washers, and spacers CA UT ION: STEP 5 - Option 1: Attaching the mounting hardware to TVs with a flat back J 10 STEP 5 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs Youl l need E Page Removing the TV from the wall plate