Dyson DCO1 Remove soleplate, Line up brush bar, Centralise belt, Thread removal, Helpline, 01666

3. Changing the belt	W A R N I N G ! For your own safety please
Replacement belts are available direct from	remember to unplug the machine when not
	in use and before carrying out maintenance.
Dyson Customer Care (Tel: 01666 827272)
1. Remove soleplate	2. Line up brush bar
1 Undo three cross-head screws.
2 Remove soleplate by lifting from the back, and then	1 Fit belt over motor
remove brush bar.	shaft and domed
	section of brush bar.
IMPORTANT Use only genuine Dyson belts.	2 Pull belt taut and	1
	locate brush bar
	in slot.	2
	End cap of brush bar
	2	With raised section
2	Raised section	on end of brush bar
		orientated as
		shown, locate brush
		bar in slot and
		rotate end cap
1		towards back of
		machine until it
		comes to a stop.
1
1
3	3. Centralise belt
	VERY IMPORTANT
	Rotate brush bar by
Cradle	hand to centralise
	belt before re-fitting
Soleplate
	soleplate to machine.
3 If cradle becomes detached from soleplate, align

circular ends of cradle with corresponding holes of soleplate and slot into place, ensuring that ‘front’ edge of cradle faces the right direction.

Thread removal

After unplugging the cleaner, carefully remove any entwined cotton, wool or fluff with scissors.

NOTE: Failure to remove these may result in loss of performance and possible damage to the machine.

Helpline	01666 827272	D Y S O N C U S T O M E R C A R E
		T E T B U R Y H I L L
Facsimile	01666 827298	M A L M E S B U R Y
		W I L T S H I R E

Contact for all service assistance	E N G L A N D
	S N 1 6 O R P