Eagle Electronics 500CDF manual Alignment letters Positions Transducer

Alignment letters

	Alignment
	positions
Transducer	Transducer
bracket
Insert and align ratchets.
Transducer bracket	Transducer

RatchetRatchet

Add ratchets to bracket and transducer.

2.Aligning the transducer on the transom.

A. One-piece bracket: Slide the transducer between the two ratch- ets. Temporarily slide the bolt though the transducer assembly and hold it against the transom. Looking at the transducer from the side, check to see if it will adjust so that its face is parallel to the ground. If it does, then the "A" position is correct for your hull.

If the transducer's face isn't parallel with the ground, remove the transducer and ratchets from the bracket. Place the ratchets into the

14