5.Use the two short M5x10 screws to screw the mounting brackets to the sides of the radio.
6.Screw each M5x32 screw through the screw hole in the mounting bracket, then attach the stopper. If your bulkhead exceeds 0.51” (13mm), the stopper can be discarded if necessary.
7.Tighten the M5x32 screws until the radio is held firmly against the rear of the bulkhead.
Install the Microphone Bulkhead Mount
1.Hold the microphone bulkhead mount at the chosen location and use a soft pencil to mark the screw hole positions on the mounting surface.
Ensure that the microphone curly cable will comfortably reach this location BEFORE you drill.
2.Drill the two pilot screw holes where marked.
3.Use a short length Philips screwdriver and the set of two flat screws, spring washers, plain washers, and nuts to secure the microphone bulkhead mount at the location site.
4.Hang the microphone on its mount.
MM
MM
MM
8 | EAGLE |
