Eagle Electronics EVR-100 manual Connect the Radio Cables

Connect the Radio Cables

The connectors are on the rear of the base unit, as follows:

1.External Speaker connector. Plug the external speaker cable jack into the connector BEFORE powering on the radio. Use a 4 Ohm 4 Watt external speaker.

2.RED Power wire. Connect this to the POSITIVE (+) battery terminal. Check that a 3 Amp fuse is installed on this power cable close to the battery.

3.BLACK Power wire. Connect this to the NEGATIVE (-) battery terminal.

4.ANT. A radio antenna is not supplied. A suitable radio antenna must be mounted and connected before operating the EVR-100 radio. Consult your dealer for advice if necessary.

5.GND. A ground connection is not usually required.

4

1

2

3 5

EAGLE EVR-100Operation Instructions 9