![](/images/new-backgrounds/1302329/3023295x1.webp)
sg82 amend p8.qxd 19/01/00 12:35 Page 3
SAFETY OPERATING INSTRUCTIONS
! | PLEASE READ BEFORE | The spray gun must not be cleaned | |
by using flammable liquids with a | |||
USE | |||
flash point of less than 32oC. | |||
| |||
NEVER under any circumstances | |||
aim the nozzle at another person or | |||
animal. In the event of injury | 2.5m/s2. | ||
occuring seek expert medical | NEVER spray near a naked flame, | ||
advice immediately. | including appliance pilot flame. | ||
The spray gun must not be used for | NEVER smoke whilst spraying. | ||
spraying flammable paints and | NEVER allow children to operate or | ||
solvents with a flash point of less | |||
than 32oC. | play with the spray gun. | ||
Always ensure there is adequate | Before cleaning, always disconnect | ||
from the mains supply. | |||
ventilation when spraying. | |||
Always disconnect from mains | |||
We recommend the use of ear | |||
supply when refilling the paint | |||
protectors. | |||
container. | |||
We recommend the use of eye | |||
After every use ensure you clean | |||
protection to keep hazardous | |||
your spray gun thoroughly and | |||
vapours out of eyes. | |||
ALWAYS LUBRICATE THE | |||
Always wear a mask when | |||
PISTON. | |||
spraying. | It is recommended that a RCD | ||
Always read the paint | |||
(residual current device) rated at | |||
manufacturers thinning instructions | 30mA is fitted into the mains supply | ||
before using. | socket for added protection against | ||
Always keep the spray basket | electric shock. | ||
nozzle in place during use. Never | NEVER USE THE SPRAY GUN | ||
allow the spray to come in direct | OUTSIDE WHEN IT IS RAINING. | ||
contact with the skin. |
|
PLEASE NOTE
We have done all we can to ensure that used correctly and according to these instructions, the Earlex SG85 Electric Airless Spray Gun will give long trouble free service. We accept no responsibility for damage caused by the use of incorrect or unsuitable substances, paint or fluids which have not been thinned correctly or are unsuitable for the surfaces to which they are applied, health hazards arising from lack of ventilation when working in confined spaces, or failure of the equipment due to inadequate cleaning of components after use.
If in doubt, always test a small inconspicuous area first. Always read the paint manufacturers instructions first.
Neither our guarantee nor the above statement affect your statutory rights.
3