WHAT’S INCLUDED
The following components are included in this product.
WD0001 | Collection Bin |
WD0035 | Hose Inlet |
WD0036 | Crevice Tool |
WD0045 | Castors x 4 |
WD0050 | Hose |
WD0217 | Motor Housing |
WD0083 | Floor Head |
Follow these simple instructions to assemble your CombiVac® before use.
1.Remove all packing materials and remove unit from box.
2.Release the two tank clips on either side of the black rim and lift
the motor housing off the collection bin.
3.Remove all accessories from inside the tank.
4.Fit castors into outriggers. Ensure the castors are fitted all the way in.
5.Turn the collection bin upside down and fit the
outriggers into the holes in the bin.
6.Push the hose inlet into the side of the recovery tank. It must be pushed
in from the outside of the tank, ensuring that the lug on the hose inlet
is lined up with the slot in the tank as shown.
7.Pull the hose inlet from inside the tank and pull with an up and down motion to engage. Make sure the clips on the top and bottom of the
hose inlet are fixed into place inside the tank. Once installed, the hose inlet can remain in place permanently.
WD0147 | Outlet Elbow |
WD0178 | Cellulose Cartridge Filter |
WD0181 | Power Tool Adaptor |
WD0182 | Floor Head Brush/Squeegee Attachment |
WD0183 | Outriggers x 4 |
WD0188 | Dust Collection Bag |
WDACC4 | Extension Tubes |
FITTINg THE FILTER
& DUST COLLECTION BAg
WARNINg - DISCONNECT FROM POWER SUPPLY BEFORE OPENINg
CAUTION
NEVER OPERATE THIS UNIT WITHOUT THE CORRECT FILTER FITTED.
Failure to do so will invalidate the guarantee. A clean filter is essential to this unit for it to operate efficiently. If the filter becomes clogged or damaged, or fails to operate, you must fit an Earlex replacement. Please call 01483 454666 for more information or visit our website www.earlex.com
8.Turn the motor housing upside down and push the filter down over the float cage.
9.Push the filter all the way down to the base of the motor housing taking care not to squash the filter pleats.
10.Fasten the pin into the centre of the base of the filter and push all the way in.
11.To remove the filter, pull the pin out of the base of the filter and pull the filter off the float cage, taking care not to squash the filter pleats.
3
