Attaching hopper extension to hopper
For European models only (9050140, 9060140, and 9010140)
Tools Required:
5/32” Hex drive wrench (i.e: allen wrench) 7/16”Wrench for
NOTE: Assemble extension before adding fuel or engine oil.
To attach the hopper extension:
1)Before bolting the handle into position, slide one hopper ex- tension half (1709470) over the rim of the hopper. The groove around the inside bottom of the hopper extension should fit over the rim around the top of the hopper. SEE FIGURE 22.
2)Ensuring the hopper and hopper extension holes are now aligned along the top rim of the hopper, place a
NOT fully tighten hardware at this point. SEE FIGURE 22.
3)Bolt handle into position using appropriate hardware. Lay the unit down, resting the handle on a piece of cardboard to pre- vent scratching.
4)Follow Step 1 to install the second extension half to the opposite side of the hopper. Again, the bottom groove of the hopper extension should fit over the rim at the top of the hopper. Align the bolt holes between the top of the hopper and bottom of the hopper extension and insert hardware. SEE FIGURE 23.
5)Place a
6)Place bolt through each of the two holes on top of the joined hopper extension. Secure with flat washer and flange nut. SEE FIGURE 25.
7)Once all hardware has been inserted, use 5/32” allen wrench and 7/16” wrench to fully tighten all hardware, including those around hopper rim and along the hopper extension seams.
hopper extension |
|
ange nut |
|
at washer | |
| |
|
Figure 22
hopper extension
r | ange nut | |
at washer | ||
|
Figure 23
Figure 24
Figure 25
Page 12
GetEarthquake.com
