PA-600 AMPLIFIER CONNECTION (STEREO & MONO)
The | 2 to 8 ohms range | |||||
two separate power amplifiers, each capable | ||||||
of driving loads down to 2 ohms. Each |
| |||||
channel operates independently and has its |
| |||||
own input connectors, sensitivity level |
| |||||
controls, | signal | indicator | LEDS, | limiter | 2 to 8 ohms range | |
circuitry, | fault | protection | circuitry, | power | ||
| ||||||
amp, and speaker outputs.
In Stereo Mode, the STEREO/MONO SWITCHE must be in the "STEREO" position. Either the binding posts or the Phone jacks may be used to connect the amplifier to the speakers. Both inputs must be active (plugged) in stereo mode; either XLR input, RCA input, or the Phone Jack input can be used.
The two internal power amplifiers may be | From audio source | From audio source |
bridged together to form a single, higher- |
|
|
powered amp. In the Bridged Mono Mode, |
|
|
the amplifier uses channel #1 INPUT jacks |
|
|
and LEVEL CONTROL; channel #2 inputs |
|
|
are disconnected. Channel #2 power amp |
|
|
receives its signal from channel #1 input |
|
|
This signal is connected to channel 2 prior to |
|
|
its Limiter, so each channel is independently |
|
|
protected. The STEREO/MONO SWITCH |
|
|
must be in the MONO position. Because both |
|
|
channels are being used (bridged in series), |
|
|
the minimum load impedance is 4 ohms. |
|
|
The RED binding post terminals (ch 1="+", ch 2=" + ") or the middle Phone jack (ch #1) must be used to connect the amplifier to the speakers.
From audio source
4 to 8 ohms range
NOTE: Use both Red Terminals ONLY
in Mono Mode
Specifications & features are subject to change without notice. | www.earthquakesound.com |
