Kodak 7520 manual Replacement procedures, Changing the lamps

Replacement procedures

Changing the lamps

Replacement procedures should be performed on an as-needed basis. Components that need periodic replacement include the exposure lamps and imaging guides.

The exposure system consists of two special, long-life fluorescent lamps. The lamps slide in and out of the scanner for easy lamp replacement:

∙Always replace both lamps at the same time. If both lamps are not replaced, exposures may not be acceptable.

∙Use recommended lamps only. Other lamps may result in unacceptable image quality.

Change the lamps every 500 hours, when required for error recovery, or when image quality is poor.

WARNING: Make sure the lamps are cool before attempting to remove them from the lamp socket holder.

To change the lamps:

1.Turn the power switch off.

2.Open the side access door.

3.Release the rear lamp cable connector from the scanner electrical system.

5-14 A-61140 January 1999